I recently installed the latest Zend Core on my iSeries and ran into a few issues...
1. The interactive installation procedure is missing the trailing ")" from the end of the command. An obvious typo that most of us would correct before the first attempt but I could see an OS/400 novice running into problems. The typo is in both the installation guide and the users guide.
2. Zend Network Update will not work until a valid Network User ID and password are entered using the Setup Tool (go ZENDCORE/ZCMENU). The problem is that if you don't do that the update will silently fail and report that all components are at the latest release.
General discussion on Zend Core for IBM System i
1 post • Page 1 of 1